Engineering, 19.07.2019 20:30 aliciapinto13

Alight pressure vessel is made of 2024-t3 aluminum alloy tubing with suitable end closures. this cylinder has a 90mm od, a 1.65mm wall thickness, and poisson's ratio 0.334. the purchase order specifies a minimum yield strength pf 320 mpa. what is the factor of safety if the pressure-release valve is set at 3.5 mpa?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

You know the right answer?

Alight pressure vessel is made of 2024-t3 aluminum alloy tubing with suitable end closures. this cyl...