Engineering, 19.07.2019 20:20 misskylie2003

A150.00 mm sine bar is used to inspect a part angle that has a dimension of 35.0? 1.0°. the sine bar rolls have a diameter- 25.0 mm. a set of gage blocks is available that can form any height from 10. mm to 199.995 mm in increments of 0.005 mm. all inspection is performed on a surface plate. determine (a) the height of the gage block stack to inspect the minimum angle, (b) the height of the gage block stack to inspect the maximum angle, and (c the smallest increment of angle that can be set up at the nominal angle size.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

You know the right answer?

A150.00 mm sine bar is used to inspect a part angle that has a dimension of 35.0? 1.0°. the sine ba...