subject
Engineering, 17.07.2019 23:40 keniaguevara32

An actual refrigerator operates on the vapor-compression refrigeration cycle with refrigerant-22 as the working fluid. the refrigerant evaporates at −15°c and condenses at 40°c. the isentropic efficiency of the compressor is 83 percent. the refrigerant is superheated by 5°c at the compressor inlet and subcooled by 5°c at the exit of the condenser. the properties of r-22 in the case of actual operation are h1 = 402.49 kj/kg, h2 = 454.00 kj/kg and h3 = 243.19 kj/kg. the properties of r-22 in the case of ideal operation are h1 = 399.04 kj/kg, h2 = 440.71 kj/kg and h3 = 249.80 kj/kg. note: state 1: compressor inlet, state 2: compressor exit, state 3: condenser exit, state 4: evaporator inlet. a) the heat removed from the cooled space is (kj/kg)b) the work input is (kj/kg) c) the cop is

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
image
Engineering, 04.07.2019 19:10, santosbeti90
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
You know the right answer?
An actual refrigerator operates on the vapor-compression refrigeration cycle with refrigerant-22 as...

Questions in other subjects:

Konu
Mathematics, 02.09.2019 17:00