Engineering, 15.07.2019 09:10 koryn4880

28. technician a says that during one four-stroke cycle of a cylinder, the crankshaft completes
one revolution. technician b says that during one four-stroke cycle of a cylinder, the camshaft
completes one revolution. who is wrong? explain why?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

Engineering, 06.07.2019 03:20, demotte79991

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

continue

You know the right answer?

28. technician a says that during one four-stroke cycle of a cylinder, the crankshaft completes