Engineering, 12.07.2019 23:30 silviarahnama
An aluminium alloy used for making cans is cold rolled into a strip of thickness 0.3mm and width 1m. it is coiled round a drum of diameter 15cm, and the outer diameter of the coil is 1m. in the cold rolled condition, the dislocation density is approximately 1015 m-2. estimate: (i) the mass of aluminium on the coil; (ii) the total length of strip on the coil; (iii) the total length of dislocation in the coiled strip.
Answers: 3
Engineering, 03.07.2019 15:10, breannaasmith1122
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
An aluminium alloy used for making cans is cold rolled into a strip of thickness 0.3mm and width 1m....
Mathematics, 09.02.2021 05:20
Mathematics, 09.02.2021 05:20
Chemistry, 09.02.2021 05:20