subject
Engineering, 12.07.2019 21:20 josmanu235

Acylindrical container, who contained pressure, is to have a circular plate welded in one end with complete fillet welds laid around the edge of the plate facing into the container and the edge of the plate facing out of the container. the container has an internal diameter of 500mm. the steel from which the plate is made has an elastic modulus of 200gpa and a poisson's ratio of 0.3. se wall thickness is considerably more than is required to resist the i)- how you would categorise this edge support? ii)- determine the minimum thickness the plate should have if it is to resist a pressure of 1 mpa without anywhere experiencing a stress greater in magnitude than 100 mpa

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
image
Engineering, 04.07.2019 18:20, CelesteN64
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
image
Engineering, 04.07.2019 19:10, kimmy6973
What is creep? what is stress relaxation?
Answers: 1
You know the right answer?
Acylindrical container, who contained pressure, is to have a circular plate welded in one end with c...

Questions in other subjects: