Engineering, 11.07.2019 04:30 lele2010

Aclosed gas turbine unit uses helium as the working fluid. there are two stages of compression with intercooling from 480kpa and 290k to a maximum pressure of 2.75mpa with an intermediate pressure of 1149kpa. the regenerator has an effectiveness of 60% and delivers the helium to the high-temperature heat exchanger, where it is heated to 890k. there are two turbine stages, the first discharging at 1170kpa. following the first turbine stage, a heat exchanger re-heats the helium to 890k. the second turbine exhausts at 480kpa to the regenerator. all the expansion and compression processes are isentropic. a)- the compressor work per kilogram b)- the turbine work per kilogranm c)- the heat added to the cycle per kilogram d)- the thermal efficiency e)- the power output for a helium flow rate of 45kg/s

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

You know the right answer?

Aclosed gas turbine unit uses helium as the working fluid. there are two stages of compression with...