Engineering, 11.07.2019 04:20 mzyjohnson47
One end of a very long aluminum rod (k= 200 w/m. c) with a diameter of 5 mm is kept at 130 c. if the ambient temperature surrounding the rod, t? is at 30 c and the heat transfer coefficient, h is 120 w/m2 .c. find: a. the temperature distribution in the rod. b. the rate of heat transfer from the rod. c. find what the actual length of the rod must be in order for the infinite length assumption to represent an accurate model d. if instead of aluminum, stainless steel (k= 15 w/m. c) is used would the actual length noted in part c for an accurate infinite length model be higher or lower than what was calculated in part b.
Answers: 1
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:20, alexis9263
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
One end of a very long aluminum rod (k= 200 w/m. c) with a diameter of 5 mm is kept at 130 c. if the...
History, 11.03.2020 18:07
Mathematics, 11.03.2020 18:07
English, 11.03.2020 18:07