Engineering, 11.07.2019 04:20 dpazmembreno

Two large plane surfaces are 2.8 cm apart. the space between the surfaces is filled with glycerine. what force is required to drag a very thin plate of surface area of 0.6 m^2 between the two large plane surfaces at a speed of 1.5 m/s, if (i) the thin plate is in the middle of the two plane surfaces, and (ii) the thin plate is at a distance of 0.7 cm from one of the plane surfaces? assume the kinematic viscosity ofglycerine is 1.19×10^-3 m^2/s

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

You know the right answer?

Two large plane surfaces are 2.8 cm apart. the space between the surfaces is filled with glycerine....