subject
Engineering, 11.07.2019 04:20 Annlee23

An otto cycle, analyzed using cold air-standard assumptions, has a a)-if the thermal efficiency of the cycle is 0.57, find the specific work b)- plot the thermal efficiency as a function of the compression ratio c)- based partially on the previous plot, would you continue peak temperature of 2500 k and a peak pressure of 60 bar during the isentropic expansion. for a cold air-standard otto cycle, using values of r =5,10,15,20. increasing the compression ratio, without reservations, in an actual design? explain.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, danksans7011
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
An otto cycle, analyzed using cold air-standard assumptions, has a a)-if the thermal efficiency of t...

Questions in other subjects:

Konu
Geography, 16.02.2021 01:00
Konu
Mathematics, 16.02.2021 01:00
Konu
History, 16.02.2021 01:00