Engineering, 11.07.2019 02:30 kirathadoll

Consider a 210-mw steam power plant that operates on a simple ideal rankine cycle. steam enters the turbine at 10 mpa and 500°c and is cooled in the condenser at a pressure of 10 kpa. (a) show the cycle on a t-s diagram with respect to saturation lines, and determine the followings (b) the quality of the steam at the turbine exit, (c) the thermal efficiency of the cycle; (d) the mass flow rate of the steam

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:10, jesuslovesusall3

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

continue

Engineering, 06.07.2019 02:30, cofran

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

continue

You know the right answer?

Consider a 210-mw steam power plant that operates on a simple ideal rankine cycle. steam enters the...