Engineering, 11.07.2019 01:30 crun
The air velocity in the duct of a heating system is to be measured by a pitot-static probe inserted into the duct par- allel to the flow. if the differential height between the water columns connected to the two outlets of the probe is 2.4 cm determine (a) the flow velocity and (b) the pressure rise at the tip of the probe. the air temperature and pressure in the duct are 45°c and 98 kpa, respectively
Answers: 1
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
The air velocity in the duct of a heating system is to be measured by a pitot-static probe inserted...
Questions in other subjects:
Biology, 12.12.2019 01:31
