Engineering, 11.07.2019 01:10 victoriadorvilu

Water-to-water heat pumps are recently being employed to produce hot water, in-stead of gas water heaters. a water-to-water vapor compression heat pump cycle using 134-a as a working fluid operates between pressure limits of 200 kpa and 1600 kpa to produce hot water in winter. assume the isentropic efficiency of the compressor to be 85 percent determine the energy required to produce 100 gpm of hot water for 4000 hours of operation per year. what is the maximum temperature at which hot water can be produced? note: there should be at least 10°c of temperature difference between the water and the refrigerant fluid in the evaporator and condenser of the heat pump at inlet and exit of each device.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

You know the right answer?

Water-to-water heat pumps are recently being employed to produce hot water, in-stead of gas water he...