The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

In an engine working on the diesel cycle the ratios of the weights of air and fuel supplied is 50: 1. the temperature of air at the beginning of the compression is 60 °c and the compression ratio used is 14: 1. what is the ideal efficiency of the engine. calorific value of fuel used is 42000 kj/kg. assume c, = 1.004 kj/kg k and c 0.717 kj/kg k for air