Computers and Technology, 24.10.2021 05:40 salmanderabdi12

Ultrasonic + RGB LED + Thermistor + DC motor 1.Write an Arduino program where the Thermistor reads in the temperature measurements.
2.When the temperature rises above the threshold set by you, the DC motor and the RGB LED are turned ON.
3.Finally, program the ultrasonic sensor to turn OFF the RGB LED and the DC motor when you pass your hand over it.

Answers: 2

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 22.06.2019 01:30, gabriieldelacruz16

What “old fashioned” features of checking accounts is p2p replacing

Answers: 3

continue

Computers and Technology, 22.06.2019 21:00, jennifer7037

Ulia is planning to attend the same private four-year college her parents attended. she wants to save at least $18,000 in four years to contribute to her college education. which monthly deposit amounts can julia use to achieve her goal? check all that apply.

Answers: 2

continue

Computers and Technology, 23.06.2019 01:50, jumoke26

Create a class named majors that includes an enumeration for the six majors offered by a college as follows: acc, chem, cis, eng, his, phys. display the enumeration values for the user, then prompt the user to enter a major. display the college division in which the major falls. acc and cis are in the business division, chem and phys are in the science division, and eng and his are in the humanities division. save the file as majors. java.

Answers: 2

continue

Computers and Technology, 23.06.2019 15:30, jasssp

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Answers: 2

continue

You know the right answer?

Ultrasonic + RGB LED + Thermistor + DC motor 1.Write an Arduino program where the Thermistor reads...