Computers and Technology, 22.10.2021 23:40 eliza35

The String otherObjects() method relies on the . a) name. indexOf() method
b) name. equals() method
c) name. compareTo() method
d) name. length()

Answers: 1

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 22.06.2019 03:10, brylove603

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it must not appear in the factorization. sample runs are given below. note that if the power of a prime is 1, then that 1 must appear in t

Answers: 3

continue

Computers and Technology, 22.06.2019 11:00, Lacey9319

The editing of digital photos us about the same level of difficulty as editing an analog photo

Answers: 2

continue

Computers and Technology, 22.06.2019 23:30, lexirandall19

Define a function printfeetinchshort, with int parameters numfeet and numinches, that prints using ' and " shorthand. ex: printfeetinchshort(5, 8) prints: 5' 8"

Answers: 1

continue

Computers and Technology, 23.06.2019 15:30, jasssp

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Answers: 2

continue

You know the right answer?

The String otherObjects() method relies on the . a) name. indexOf() method
b) name. equals()...