Fill in multiple blanks for [x], [y], [z]. Consider a given TCP connection between host A and host B. Host B has received all from A all bytes up to and including byte number 2000. Suppose host A then sends three segments to host B back-to-back. The first, second and third segments contain 50, 600 and 100 bytes of user data respectively. In the first segment, the sequence number is 2001, the source port number is 80, and the destination port number is 12000. If the first segment, then third segment, then second segment arrive at host B in that order, consider the acknowledgment sent by B in response to receiving the third segment. What is the acknowledgement number [x], source port number [y] and destination port number [z] of that acknowledgement

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."