A source needs to transmit data packets to a receiver over a radio link. The receiver uses error detection to identify packets that have been corrupted by radio noise. When a packet is received error-free, the receiver sends an acknowledgment (ACK) back to the source. When the receiver gets a packet with errors, a negative acknowledgment (NAK) message is sent back to the source. The packet is retransmitted each time the source receives a NAK. We assume that each packet transmission is independently corrupted by errors with probability q. Find the PMF of X, the number of times that a packet is transmitted by the source.

3. (5 points) describe what would be printed by the code below or what error would occur. const char* cstr = "0123456"; const char* ptr = & cstr[4]; cout < < ptr[-1] < < ptr < < endl; 1 4. (5 points) theseus has been trapped in a maze with a minotaur, which is trying to capture him. each round, theseus and the minotaur move through the maze; theseus towards the exit, and the minotaur towards theseus. theseus can move in any of the four cardinal directions, or he can wait for a round to see how the minotaur moves. write code that creates a data type to represent the possible moves that theseus could make.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Pthreads programming: create and terminate a thread write a c++ program that creates a thread. the main will display a message “hello world from the main”. the main will create a thread that will display a message “hello world from the thread” and then terminates with a call to pthread_exit()