13. A 2-sided coin has an equal likelihood of landing on each side. One side is called "heads" and the other is called "tails". The program below simulates randomly flipping that coin many times,
var heads -
var tails - ;
var rolls - 100;
for(var i=0; i
if(randonlumber(0,1) - )
heads
} else
tails
Which of the following is NOT a possible combination of values of the variables in this program when it finishes running?
O A. tails has a value of O and heads has a value of 100
B. tails has a value of 100 and heads has a value of O
0 C. tails has a value of 20 and heads has a value of 20
O D. tails has a value of 50 and heads has a value of 50

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

Write a function so that the main program below can be replaced by the simpler code that calls function original main program: miles_per_hour = float( minutes_traveled = float( hours_traveled = minutes_traveled / 60.0 miles_traveled = hours_traveled * miles_per_hour print('miles: %f' % miles_traveled) sample output with inputs: 70.0 100.0 miles: 116.666667

Me with this program in c++ ! computers represent color by combining sub-colors red, green, and blue (rgb). each sub-color's value can range from 0 to 255. thus (255, 0, 0) is bright red. (130, 0, 130) is a medium purple. (0, 0, 0) is black, (255, 255, 255) is white, and (40, 40, 40) is a dark gray. (130, 50, 130) is a faded purple, due to the (50, 50, 50) gray part. (in other word, equal amounts of red, green, blue yield gray).given values for red, green, and blue, remove the gray part. ex: if the input is 130 50 130, the output is: 80 0 80. thus, find the smallest value, and then subtract it from all three values, thus removing the gray.