N Which best describes the relationship between hardware and software?
ОООО
Software instructs hardware how to perform.
Software allows users to interact with hardware.
Hardware directs the performance of software.
Hardware enables software to perform correctly.
The answer is CC equals hardware distract supposed formants of software hope this helps

Which is the correct sequence of steps to set up a document in landscape orientation? a. select page setup from the file menu. then click the margins tab and select landscape. b. select page setup from the edit menu. then click the margins tab and select landscape. c. select page setup from the insert menu. then click the margins tab and select landscape. d. select page setup from the format menu. then click the margins tab and select landscape

Barbara is interested in pursuing a career in the science and math pathway. which qualifications will her reach that goal? a. an advanced knowledge of physics and math b. an advanced knowledge of engineering and math c. an advanced knowledge of physics and robotics an d. advanced knowledge of machinery and math

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."