Computers and Technology, 18.03.2021 01:20 katiebonar13

Create a new sketch using the Arduino IDE and replace it with the following code. Write your own statements to read in the input value (10-bit unsigned int), cast (convert) that reading to a floating point value, convert the brightness value into voltage using the formula above then print the voltage to the serial port. You will need to make use of the analogRead and Serial. println functions.

Answers: 2

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 23.06.2019 06:30, eddsworldfrantic

You have a small company and want to keep your costs low, but it is important your employees share data. which network would provide you with the most economical solution?

Answers: 1

continue

Computers and Technology, 23.06.2019 16:30, 19thomasar

How to do this programming flowchart?

Answers: 3

continue

Computers and Technology, 23.06.2019 21:30, quintonps12

Which of the following includes the three primary network access technologies? dsl, cable modem, broadband lan, wan, man voip, uc, iptv tcp/ip, ftp, dhcp

Answers: 2

continue

Computers and Technology, 23.06.2019 21:40, minnie7760

Draw the resistor’s voltage and current phasors at t=15ms. draw the vectors with their tails at the origin. the orientation of your vectors will be graded. the exact length of your vectors will not be graded.

Answers: 2

continue

You know the right answer?

Create a new sketch using the Arduino IDE and replace it with the following code. Write your own sta...