For each problem, below, write a single Verilog statement to achieve the desired result in the context of the standard top module of the Verilog/FPGA simulator. Use the simulator to check your work. a. Connect ss7[0] to a logic
b. Connect ss7[1] to a logic low
c. Connect ss 7[2] to a pb[0].
d. Connect ss7[3] to the complement of pb[1].
e. Connect ss7[4] to Boolean product of pb[2] AND pb[3].
f. Connect ss7[5] to Boolean sum of pb[4] OR pb[5] OR pb[6].

How do i delete my account on this because i didn't read this agreements and also i put age at xd

From excel to powerpoint, you can copy and paste a. cell ranges and charts, one at a time. b. cell ranges and charts, simultaneously. c. charts only. d. cell ranges only.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."