A local biologist needs a program to predict population growth. The inputs would be: The initial number of organisms
The rate of growth (a real number greater than 1)
The number of hours it takes to achieve this rate
A number of hours during which the population grows

For example, one might start with a population of 500 organisms, a growth rate of 2, and a growth period to achieve this rate of 6 hours. Assuming that none of the organisms die, this would imply that this population would double in size every 6 hours. Thus, after allowing 6 hours for growth, we would have 1000 organisms, and after 12 hours, we would have 2000 organisms.

Write a program that takes these inputs and displays a prediction of the total population.
An example of the program input and output is shown below:

Enter the initial number of organisms: 10
Enter the rate of growth [a real number > 0]: 2
Enter the number of hours to achieve the rate of growth: 2
Enter the total hours of growth: 6

The total population is 80

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

Which best describes the condition under which the unicode output is the same as plain text?

State 7 common key's for every keyboard