200 points and brianlist if. done correctly... When working in Scratch, after clicking on the Choose Backdropicon and making your selections, where will your choices show up? Group of answer choices

on the left side of the Backdropsscreen

on the right side of the Backdropsscreen

at the bottom of your screen

in a pop-up bubble in the center of the screen

Answer the following questions regarding your system by using the commands listed in this chapter. for each question, write the command you used to obtain the answer. a. what are the total number of inodes in the root filesystem? how many are currently utilized? how many are available for use? b. what filesystems are currently mounted on your system? c. what filesystems are available to be mounted on your system? d. what filesystems will be automatically mounted at boot time?

Http is the protocol that governs communications between web servers and web clients (i. e. browsers). part of the protocol includes a status code returned by the server to tell the browser the status of its most recent page request. some of the codes and their meanings are listed below: 200, ok (fulfilled)403, forbidden404, not found500, server errorgiven an int variable status, write a switch statement that prints out the appropriate label from the above list based on status.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."