Question # 4 Multiple Choice
Which step comes first?

Process the data.

Gather data from the user.

Check for accuracy.

Define the problem.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

When using a public computer or network, you should always

You need to design a circuit that implements the functions in the following table: s0 s1 function0 0 a + 10 1 a – b1 0 a + b1 1 a – 1s0 and s1 are 1-bit control inputs to select the function of the circuit. inputs a and b are 4-bitnumbers in 2s complement form. the output is also a 4-bit number in 2s complement form. you are allowed to use only one ttl 7483 4-bit adder to implement all the functions. but anynumber of other components (except the adder) can be used. hint: design a combinational logic circuit to modify the input b and the “carry input” of theadder depending on the control inputs s0 and s1.important: lab grade will depend on the working of the circuit & will be checked of by your labinstructor.1. is the output valid for the following input combinations: a. s0 = 0, s1 = 0, a = 7, b = 3? b. s0 = 0, s1 = 1, a = 7, b = 3? c. s0 = 1, s1 = 0, a = -4, b = -5? d. s0 = 1, s1 = 1, a = -8, b = 6? 2. what is the range of inputs (for both a and b) that will produce the valid output for all the functions?