Fill in the blanks y'all- is a pictorial representation of a step-by-step algorithm

I will give brainliest, just answer quick :)

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Which best describes the condition under which the unicode output is the same as plain text?

[a] create a class called “cycle” which has two instance integer variables as properties, “numberofwheels” and “weight.” create a constructor with two parameters, using the same variable names in the parameter list. assign each variable to numberofwheels” and “weight” respectively. write a separate application to test the class and display its properties. note: do not change the names of the instance variables or the variables listed in the constructor’s parameter list. [b] edit your class cycle by adding a default constructor which will assign the default values of 100 to represent the numberofwheels, and 1000 to represent the weight, by invoking a call to the other constructor. modify your application created in [a] to test the class.