What will you see on the next line?
>>> int(13.6)

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

Data is processed, stored, and transmitted as a series of 1s and 0s. each 1 or 0 is called a(n) . a series of eight 0s and 1s, called a(n) , represents one character—a letter, number, or punctuation mark. data becomes when it is presented in a format that people can understand and use. digital signals are represented by two different , such as +5 volts and +.2 volts. digital data can also take the form of light and dark spots etched onto the surface of a cd or the positive and negative orientation of particles on the surface of a hard disk. data consists of numbers that might be used in arithmetic operations. it can be represented digitally using the number system. data is composed of letters, symbols, and numerals that are not used in arithmetic operations. computers represent this type of data using , ebcdic, unicode, or utf-8. data is quantified using terms such as or kibibyte (1024 bytes), and prefixes such as or mebi (1,048,576), and giga or (1,073,741,824). to reduce file size and transmission times, digital data can be compressed. compression provides the means to compress data and reconstitute it into its original state. compression throws away some of the original data during the compression process. compressed files usually have at the end of the file name and are represented with special icons. these files have to be or unzipped before you can view the data they contain.

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it must not appear in the factorization. sample runs are given below. note that if the power of a prime is 1, then that 1 must appear in t