Question is on the picture thank you

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

What makes myhexadecimalnumber a child of mynumber? which methods does myhexadecimalnumber inherit directly from the mynumber class? what can an instance of the mynumber class do? what can an instance of the myhexadecimalnumber class do? which methods are overridden? why are they overridden? how many examples of overloading are there? why was this done? where is the super keyword used? what is it doing? why isn’t the incoming value set immediately in the second myhexadecimalnumber constructor? how many examples can you find of an inherited method being called?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a. if the manual switch s is on, then the light l is on. b. besides the manual switch, there is a motion detector, m1, which activatesthis light. c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d. the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.