In this lab the completed program should print the numbers 0 through 10, along with their values multiplied by 2 and by 10. You should accomplish this using a for loop instead of a counter-controlled while loop. Instructions
Write a for loop that uses the loop control variable to take on the values 0 through 10.
In the body of the loop, multiply the value of the loop control variable by 2 and by 10.
Execute the program by clicking the Run button at the bottom of the screen. Is the output the same?

Hassan is writing his master’s thesis, which is a thirty-page document. he received some feedback from his professor in the form of comments, but does not see where the comments are. what is the fastest way for hassan to find the feedback?

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it

What is the error in the following pseudocode? module main() call raisetopower(2, 1.5) end module module raisetopower(real value, integer power) declare real result set result = value^power display result end module