Consider a reliable data transfer protocol that uses only negative acknowledgments. Suppose the sender sends data only infrequently. Would a NAK-only protocol be preferable to a protocol that uses ACKs? Why? Now suppose the sender has a lot of data to send and the end-to-end connection experiences few losses. In this second case, would a NAK-only protocol be preferable to a protocol that uses ACKs? Why?

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it must not appear in the factorization. sample runs are given below. note that if the power of a prime is 1, then that 1 must appear in t

Q-1 which of the following can exist as cloud-based it resources? a. physical serverb. virtual serverc. software programd. network device

Use a physical stopwatch to record the length of time it takes to run the program. calculate the difference obtained by calls to the method system. currenttimemillis() just before the start of the algorithm and just after the end of the algorithm. calculate the difference obtained by calls to the method system. currenttimemillis() at the start of the program and at the end of the program so that the elapsed time includes the display of the result. use the value returned by the method system. currenttimemillis() just after the end of the algorithm as the elapsed time.