Computers and Technology, 10.03.2020 01:36 krobinson27

Read/write circuitry uses data to compensate for minor variations in rotation speed and other factors that might disturb the precise timing needed for reliable reading and writing.

Answers: 2

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 23.06.2019 09:30, cdavis379

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a. if the manual switch s is on, then the light l is on. b. besides the manual switch, there is a motion detector, m1, which activatesthis light. c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d. the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

continue

Computers and Technology, 23.06.2019 19:30, Felixthecat7186

Anul 2017 tocmai s-a încheiat, suntem trişti deoarece era număr prim, însă avem şi o veste bună, anul 2018 este produs de două numere prime, 2 şi 1009. dorel, un adevărat colecţionar de numere prime, şi-a pus întrebarea: “câte numere dintr-un interval [a, b] se pot scrie ca produs de două numere prime? “.

Answers: 3

continue

Computers and Technology, 23.06.2019 20:30, lucywood2024

What is the biggest difference between section breaks and regular page breaks

Answers: 1

continue

Computers and Technology, 24.06.2019 16:00, miner12924owhu4d

5.a fishing rod is formed from a composite material of 0.5 kg of glass fibers embedded in a matrix of 0.5 kg of epoxy resin. the glass fibers are assumed to be long, continuous and unidirectional. to achieve a greater stiffness it is proposed to use a different composite that is comprised of long continuous carbon fibers that will be embedded in a matrix of 0.5 kg of epoxy resin. if the modulus of elasticity of the carbon fiber composite is 10% greater than the elastic modulus of the glass fiber composite, estimate the mass of carbon fibers that will be used to make the carbon fiber composite. assume the applied tensile stress is parallel to the direction of the long axis of the fibers. the epoxy resin, glass fiber, and carbon fiber have an elastic modulus of 5, 86, and 350 gpa respectively and a density of 1100, 2500, and 1800 respectively.

Answers: 3

continue

You know the right answer?

Read/write circuitry uses data to compensate for minor variations in rotation speed and other facto...