subject

The frame header at the Data Link layer includes hardware addresses of the source and destination NICs. What is another name for this address?

ansver
Answers: 1

Other questions on the subject: Computers and Technology

image
Computers and Technology, 22.06.2019 08:00, jcastronakaya
Apex q: what does a low employment rate indicate? a. not many people are earning high salaries b. not many people are going to college c. not many people are renting their homes d. not many people have jobs
Answers: 2
image
Computers and Technology, 22.06.2019 16:50, Tyrant4life
Consider a slotted aloha system, where the time slot equals the fixed duration of each packet. assume that there are 4 stations a, b,c, d sharing the medium. (a) stations a, b,c, d receive one packet each from higher layers at times 1.3, 1.5, 2.6,5.7 respectively. show which transmissions take place when, according to the slottedaloha protocol; describe all transmissions until all four packets have been successful. when needed, each station has access to the following sequence of random number, provided by a random number generator and drawn uniformly between 0 and 1: (1) station a draws numbers: 0.31, 0.27, 0.78, 0.9, 0.9, 0.11, 0. (2) station b draws numbers: 0.45, 0.28, 0.11, 0.83, 0.37, 0.22, 0. (3)station c draws numbers: 0.1, 0.2, 0.3, 0.4, 0. (4) station d draws numbers: 0.36, 0.77, 0.9, 0.1, 0.1, 0.1, 0.1, 0. (b) in slotted aloha, a station transmits in each time slot with a given probability. what probabilities would you assign to each of the four stations so as to: (i) maximize the efficiency of the protocol? (ii) maximize fairness among the four stations? (c) will the efficiency increase or decrease if we modify slotted aloha as follows: (i) get rid of slots and allow stations to transmit immediately? (ii) implement carrier sensing? (iii) implement collision detection? (iv) implement collision avoidance?
Answers: 3
image
Computers and Technology, 22.06.2019 23:00, brookerebman15
Which type of tab stop is most for weights and measurements?
Answers: 1
image
Computers and Technology, 23.06.2019 06:00, sebcbal
When is a chart legend used a. all the time b. whenever you are comparing data that is the same c. whenever you are comparing multiple sets of data d. only for hand-drawn charts
Answers: 2
You know the right answer?
The frame header at the Data Link layer includes hardware addresses of the source and destination NI...

Questions in other subjects: