Computers and Technology, 11.02.2020 02:37 bellamore

Which of the following are parts of the Physical Layer?

Answers: 2

Show answers

Answers

Answer from: ada1928

Physical layer is the first layer of OSI model. The detail about physical layer and its parts is given below in explanation section.

Explanation:

The physical layer is the lowest and first layer of the Open Systems Interconnection Model (OSI). The physical layer is used for the transmission of data in bit forms. For transmission of data between devices, it uses the transmission medium that is either wired or wireless.

In the wired cable the component of the psychical layer include cable and connectors that are implemented for carrying data from one place to another or simply to transmit data between two connected devices. The wireless transmission medium is used to transmit data in the form of electromagnetic signals for carrying data into a stream of bits. Over past advancements in networking technologies, rapid growth has been seen in wireless data transmission and Wi-Fi and Bluetooth communication are few names of it.

Components/Parts of Psychical Layer

In the physical layer, the hardware components used it in are the network interface cards, connectors and interfaces, intermediate devices, modems, and cables to facilitate the transmission of data between devices or from source to destination.

The network interface card (NIC)

NIC is a component installed in the computer to connect it to any available devices over the network.

Connectors and Interfaces

Connectors and interfaces are used to connect cables that are being used for transmission of data from one source to another. The decision to choose connectors and interfaces depends on the type of cable. Typical examples are RJ-45, RJ-11, V.35, HDMI, etc.

Cables

Cables are the physical components of the physical layer that carry optic or electromagnetic signals for transmission of data from source to destination in the network.

Intermediate devices

The intermediate devices are hubs and repeaters etc. The functions of these devices are to amplify or generate the signal at the intermediate point in a network.

Answer from: Quest

lol me. hope this ! lol

Answer from: Quest

The number on e is a ik that one

Other questions on the subject: Computers and Technology

Computers and Technology, 23.06.2019 07:50, kmart4062

Apython programming question: assume s is a string of lower case characters. write a program that prints the number of times the string 'bob' occurs in s. for example, if s = 'azcbobobegghakl', then your program should print number of times bob occurs is: 2

Answers: 3

continue

Computers and Technology, 23.06.2019 21:40, minnie7760

Draw the resistor’s voltage and current phasors at t=15ms. draw the vectors with their tails at the origin. the orientation of your vectors will be graded. the exact length of your vectors will not be graded.

Answers: 2

continue

Computers and Technology, 24.06.2019 01:10, jaileen84

Create a program that will take in a single x and y coordinate as the origin. after the input is provided, the output should be all of the coordinates (all 26 coordinates read from the “coordinates. json” file), in order of closest-to-farthest from the origin.

Answers: 1

continue

Computers and Technology, 24.06.2019 08:30, colebuug9

Aconsumer would pay an extra they used the rent to own program to buy the computer, rather than using cash. for all of the items, is the cheapest option over the life of the contract. the most expensive overall option is to use purchase the item.