Chris is an employee in a graphic design firm. he works confidently within a group. he also accepts and learns from constructive criticism. additionally he provides positive and constructive feedback. what does chris display?
a.
teamwork
b.
loyalty
c.
trust
d.
integrity

Match each feature of e-publishing as an advantage, a disadvantage, a threat, or an opportunity. (choices) increased collaboration digitalized out-of-print versions monopoly over digital formats requirement for a specialized digital device pairs advantage of e-publishing disadvantage of e- opportunity for e- threat to e-

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Technician a says that with self-adjusting clutch systems, the release bearing constantly rotates. technician b says that the ball bearing portion of the release bearing should be lubricated with high-temperature grease during routine maintenance. which technician is correct?