Hindley-milner type inference: give the type of the function and its arguments. if there is a type mismatch, you should explain the reason for the mismatch.

a) let f g a b = if a (a g) then b else b + 1
b) let f a b i = if a.(i) b then b i else b (i+1)
c) let f a b c i = if a c then (if b then i else i+1) else c
d) et f a b c = if a b c then c else a c b

Given a link with a maximum transmission rate of 32.8 mbps. only two computers, x and y, wish to transmit starting at time t = 0 seconds. computer x sends filex (4 mib) and computer y sends filey (244 kib), both starting at time t = 0. statistical multiplexing is used, with details as follows packet payload size = 1000 bytes packet header size = 24 bytes (overhead) ignore processing and queueing delays assume partial packets (packets consisting of less than 1000 bytes of data) are padded so that they are the same size as full packets. assume continuous alternating-packet transmission. computer x gets the transmission medium first. at what time (t = ? ) would filey finish transmitting? give answer in milliseconds, without units, and round to one decimal places (e. g. for an answer of 0.013777 seconds you would enter "13.8" without the quotes)

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Write a grading program for a class with the following grading policies: a. there are two quizzes, each graded on the basis of 10 points. b. there is one midterm exam and one final exam, each graded on the basis of 100 points. c. the final exam counts for 50% of the grade, the midterm counts for 25%, and the two quizzes together count for a total of 25%. (do not forget to normalize the quiz scores. they should be converted to a percentage before they are averaged in.) any grade of 90 or more is an a, any grade of 80 or more (but less than 90) is a b, any grade of 70 or more (but less than 80) is a c, any grade of 60 or more (but less than 70) is a d, and any grade below 60 is an f. the program will read in the student’s scores and output the student’s record, which consists of two quiz and two exam scores as well as the student’s average numeric score for the entire course and final letter grade. define and use a structure for the student reco