Given the starting point in a maze, you are to find and mark a path out of the maze, which is represented by a 20x20 array of 1s (representing hedges) and 0s (representing the foot-paths). there is only one exit from the maze (represented by e). you may move vertically or horizontally in any direction that contains a 0; you may not move into a square with a 1. if you move into the square with an e, you have exited the maze. if you are in a square with 1s on three sides, you must go back the way you came and try another path. you may not move diagonally. for this program, use can only use a single linked list.

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to