![subject](/tpl/images/cats/informatica.png)
Computers and Technology, 01.10.2019 17:30 angelaisthebest1700
This c version of a case statement is called a switch statement. the following c code chooses among four alternatives, depending on whether k has the value 0, 1, 2, or 3. switch (k) { case 0: f = i + j; break; /* k = 0 */ case 1: f = g + h; break; /* k = 1 */ case 2: f = g – h; break; /* k = 2 */ case 3: f = i – j; break; /* k = 3 */ } assume the six variables f through k correspond to six registers $s0 through $s5 and that register $t2 contains 4. what is the corresponding mips code? [hint: use the switch variable k to index a jump address table, and then jump via the value loaded. we first test k to be sure it matches one of the cases (0 ≤ k ≤ 3); if not, the code exits the switch statement.]
![ansver](/tpl/images/cats/User.png)
Answers: 3
![](/tpl/images/ask_question.png)
![](/tpl/images/ask_question_mob.png)
Other questions on the subject: Computers and Technology
![image](/tpl/images/cats/informatica.png)
![image](/tpl/images/cats/informatica.png)
Computers and Technology, 22.06.2019 10:00, banna01man
You need a reliable network for about twenty-five computers that will be distributed across a large building. it is important that the network be relatively cheap. which topology should you use?
Answers: 1
![image](/tpl/images/cats/informatica.png)
Computers and Technology, 23.06.2019 03:10, kyleereeves2007
Acomputer has a two-level cache. suppose that 60% of the memory references hit on the first level cache, 35% hit on the second level, and 5% miss. the access times are 5 nsec, 15 nsec, and 60 nsec, respectively, where the times for the level 2 cache and memory start counting at the moment it is known that they are needed (e. g., a level 2 cache access does not even start until the level 1 cache miss occurs). what is the average access time?
Answers: 1
![image](/tpl/images/cats/informatica.png)
Computers and Technology, 24.06.2019 13:00, brusawerin5969
Refer to the figure and match the theorem that supports the statement.1.if chords are =, then arcs are =.if bc = de, then arc bc = arc de2.if arcs are =, then chords are =.if arc bc = arc de, then bc = de3.diameters perpen
Answers: 3
You know the right answer?
This c version of a case statement is called a switch statement. the following c code chooses among...
Questions in other subjects:
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/obshestvoznanie.png)
Social Studies, 23.08.2019 14:10
![Konu](/tpl/images/cats/istoriya.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 23.08.2019 14:10
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/geografiya.png)
Geography, 23.08.2019 14:10