[5] < §1.8> when a program is adapted to run on multiple processors in a multiprocessor system, the execution time on each processor is comprised of computing time and the overhead time required for locked critical sections and/or to send data from one processor to another. assume a program requires t = 100 s of execution time on one processor. when run p processors, each processor requires t/p s, as well as an additional 4 s of overhead, irrespective of the number of processors. compute the per-processor execution time for 2, 4, 8, 16, 32, 64, and 128 processors. for each case, list the corresponding speedup relative to a single processor and the ratio between actual speedup versus ideal speedup (speedup if there was no overhead).

During physical science class ben and jerry connected three identical lightbulbs in parallel to a battery where happens when ben removes one of the lightbulbs from it’s socket

Which one of the following voltages should never be measured directly with a vom? a. 1200 v b. 500 v c. 800 v d. 100v

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to