Computers and Technology, 29.12.2019 15:31 qiuedhg

What will be the output if the user enters 3

Answers: 1

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 22.06.2019 14:30, qxchung7310

The “rule of 72” is used to approximate the time required for prices to double due to inflation. if the inflation rate is r%, then the rule of 72 estimates that prices will double in 72/r years. for instance, at an inflation rate of 6%, prices double in about 72/6 or 12 years. write a program to test the accuracy of this rule. for each interest rate from 1% to 20%, the program should display the rounded value of 72/r and the actual number of years required for prices to double at an r% inflation rate. (assume prices increase at the end of each year.)

Answers: 1

continue

Computers and Technology, 22.06.2019 20:30, fickllyd000

In this lab, you complete a prewritten c program that calculates an employee’s productivity bonus and prints the employee’s name and bonus. bonuses are calculated based on an employee’s productivity score as shown below. a productivity score is calculated by first dividing an employee’s transactions dollar value by the number of transactions and then dividing the result by the number of shifts worked.

Answers: 3

continue

Computers and Technology, 23.06.2019 09:00, amberpublow7

Which best describes the role or restriction enzymes in the analysis of edna a. to break dna into fragments that vary in size so they can be sorted and analyzed b. to amplify small amounts of dna and generate large amounts of dna for analysis c. to purify samples of dna obtained from the environment so they can be analyzed d. to sort different sizes of dna fragments into a banding pattern that can be analyzed

Answers: 1

continue

Computers and Technology, 23.06.2019 09:30, cdavis379

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a. if the manual switch s is on, then the light l is on. b. besides the manual switch, there is a motion detector, m1, which activatesthis light. c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d. the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

continue

You know the right answer?

What will be the output if the user enters 3
...