Chemistry, 17.01.2022 14:00 because061907

A fluoride electrode was used to determine the amount of fluoride in drinking water samples. The results given in the table below were obtained for four standards and two unknowns. Constant ionic strength and pH conditions were used. Solution Containing F-

Potential vs. SCE, mV

5.00 × 10-4 M

0.02

1.00 × 10-4 M

41.4

5.00 3 10-5 M

61.5

1.00 3 10-5 M

100.2

Unknown 1

38.9

Unknown 2

553

(a) Plot a calibration curve of potential versus log[F‑]. Determine whether the electrode system shows Nernstian response.

(b) Determine the concentration of F- in the two unknown samples by a linear least-squares procedure.

Answers: 1

Show answers

Other questions on the subject: Chemistry

Chemistry, 22.06.2019 12:20, sindy35111

Consider the reaction of a(g) + b(g) + c(g) => d(g) for which the following data were obtained: experiment initial [a], mol/l initial [b], mol/l initial [c], mol/l initial rate, mol/l. s 1 0.0500 0.0500 0.0100 6.25 x 10^-3 2 0.100 0.0500 0.0100 2.50 x 10^-2 3 0.100 0.100 0.0100 1.00 x 10^-1 4 0.0500 0.0500 0.0200 6.25 x 10^-3 what is the rate law for the reaction?

Answers: 3

continue

Chemistry, 22.06.2019 21:00, thebasedgodchri

Need what is special about water as a compound? how does water regulate climate? what drives water evaporation? why is the water vapor fresh water when it rises from the ocean? why might freshwater in the form of snow take longer to enter the water cycle again than liquid precipitation? what is an aquifer? what role do people play in the water cycle? plz just answer as many as you can ! thx if you !

Answers: 1

continue

Chemistry, 23.06.2019 05:40, MyChannelBruh6896

Convert a speed of 201 cm/s to units of inches per minute. also, show the unit analysis by dragging components into the unit‑factor slots.

Answers: 1

continue

Chemistry, 23.06.2019 09:00, ameyl

How many moles of potassium hydroxide are needed to completely react with 2.94 moles of aluminum sulfate according to the following equation:

Answers: 2

continue

You know the right answer?

A fluoride electrode was used to determine the amount of fluoride in drinking water samples. The res...