Into a 125 mL Erlenmeyer flask was added some KI and H2SO4 as described in the procedure section of this experiment. Then 3.0 mL of bleach solution was added to the flask and it was immediately titrated with 0.1261 M sodium thiosulfate solution. It required 41.26 mL of this sodium thiosulfate solution to reach the end point of the titration. What is the percentage of NaOCl in the bleach

answer : one can design an experiment using a liquid and an additive that can be added to the liquid and observe the chemical changes in the reaction species.

one would need a beaker which is filled with a known amount of the liquid in which thermometer is placed to measure the temperature changes; after addition of the additive to the liquid solution one can note down the temperature change and find whether the reaction is endothermic or exothermic in nature. by subtracting the initial temperature value with the final temperature one can find the temperature changes.

various combinations of liquid and additive can be used. liquid in this case can be a known quantity of water and additives can be epsom salt or without epsom salt the experiment can be conducted to notice the changes. water and ice, hydrogen peroxide and dry yeast, vinegar and baking soda,etc.

it is b that is the answer.

answer : third trial had the contaminated sample and the correct value for dhrxn should be 1000 kj/mol

explanation :

let us write down the given equations

equation 1 :

equation 2 :

equation 3 :

let us use hess's law to find out which 2 equations can be added to get the third equation.

let us reverse equation 2 and multiply it by 2. the new equation that we get is,

equation 4 :

let us add equation 1 & 4

the above equation is similar to equation 3 but has different value for dhrxn.

therefore third trial had the contaminated sample and the correct value for dhrxn should be 1000 kj/mol