subject
Chemistry, 01.06.2021 03:50 jdkrisdaimcc11

PLS REAL ANSWERS ONLY Question 1
Part A
Describe the sequence of adding ingredients to make the recipe for condensed tomato soup. To mix the ingredients, you have an industrial-sized vat with a capacity of 800 L. You also have the ability to heat what is in the vat and/or stir the vat, both of which require energy and therefore, cost you money. Focus on the fact that the manufacturing process should be time efficient and cost efficient in terms of energy use. Be sure to refer to the solubility charts or graphs that you find for salt and sugar during your research. Finally, presume that the tomato powder has low solubility which is not temperature dependent.

Part B
What changes could be made to optimize the manufacturing process?

ansver
Answers: 2

Other questions on the subject: Chemistry

image
Chemistry, 22.06.2019 21:30, rondonalba
Electromagnets coils of wire paper clips picked up 10 3 15 6 20 9 25 12 ms. owens' class was studying magnets. ms. owens showed her students how to make an electromagnet using a nail, a d-cell battery, and plastic coated wire. the students wrapped the wire around the nail and then attached the ends to the battery. when they were finished, they tested their magnets by investigating how many paperclips their magnets could pick up. they also tested whether they could increase the strength of their electromagnets by using more coils of wire. they recorded the class average of their results in the data table seen here. ms. owens asked her students to graph their data in a line graph. how should the students label the x-axis on their line graph? a) size of battery b) number of paper clips c) number of coils of wire d) strength of electromagnet
Answers: 2
image
Chemistry, 23.06.2019 03:00, amberskids2
You have a sample of a metal, the sample is exactly 6.02 x 1023atom, if the sample has a mass 55.85 what metal is your sample made of?
Answers: 2
image
Chemistry, 23.06.2019 05:30, smarty959
Elizabeth has two separate samples of the same substance. sample is in the liquid state, and the other is in the solid state. the two samples most likely differ in which property?
Answers: 1
image
Chemistry, 23.06.2019 07:50, alexusnicole817
Asolution is produced in which water is the solvent and there are four solutes. which of the solutes can dissolve better if the solution is heated?
Answers: 1
You know the right answer?
PLS REAL ANSWERS ONLY Question 1
Part A
Describe the sequence of adding ingredients to...

Questions in other subjects:

Konu
English, 16.12.2021 19:20