Chemistry, 02.02.2021 18:10 lopezhailey317

how does the concentration of sodium thiosulphate affect the rate of reaction in between hydrochloric acid and sodium thiosulphate

Answers: 2

Show answers

Answers

Answer from: Quest

explanation:

metals have excess of electrons whereas non-metals have deficiency of electrons. thus, in order to gain stability metals easily donate their electrons to the non-metals.

for example, electronic configuration of sodium is $1s^{2}2s^{2}2p^{6}3s^{1}$ and electronic configuration of phosphorous is $1s^{2}2s^{2}2p^{6}3s^{2}3p^{3}$ .

when a phosphorous atom and sodium atom combine together then sodium will donate is extra one electron to the phosphorous atom. as a result there will be formation of ionic bond between sodium and phosphorous.

the reaction will be as follows.

$3na + p \rightarrow na_{3}p$

there, are three sodium sodium atoms and each of them will donate its one extra electron to phosphorous atom. thus, the sub-shell of phosphorous gets completely filled.

thus, we can conclude that electrons are transferred from atoms of sodium to atoms of phosphorous. this transfer makes the sodium atoms donate one electron and the phosphorous atoms to gain one electron. as a result, the sodium and phosphorus atoms strongly attract each other.

Electrons are transferred from atoms of to atoms of this transfer makes the sodium atoms and the

Answer from: Quest

assuming that your periodic table has eighteen columns, you should highlight the four elements in the third column from the left of the table.

explanation

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the $3d$ have energy higher than those in the $4 s$ orbital while lower than those of the $4 p$ orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the $4s$ orbital is therefore filled right after $3p$ orbitals and before $3 d$ orbitals.

potassium has electron configuration $[\text{ar}] 4 s^{1}$ and calcium $[\text{ar}] 4 s^{2}$ . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration $[\text{ar}] 4 s^{2} \; 3d^{1}$ and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the $ns^{2} \; (n-1) p^{1}$ and should be highlighted as well.

Answer from: Quest

No table found. the question asks for covalent bond based on electronegativies

Answer from: Quest

Determine the wavelength of light emitted when an electron in an li2+ ion makes a transition from an orbital with n = 6 to an orbital with n = 5.

Other questions on the subject: Chemistry

Chemistry, 22.06.2019 09:00, dante766

Achemist 16 drop copper metal from copper chloride solution. the chemist place is 0.50 g of aluminum foil in a solution containing 0.75 g of copper (ii) chloride. a single replacement reaction takes place. which statement explains the maximum amount of copper that the chemist can extract using this reaction?

Answers: 1

continue

Chemistry, 22.06.2019 09:30, mazielynn84

In 2002, the rare earth elements mine in mountain pass, california was closed because

Answers: 1

continue

Chemistry, 22.06.2019 11:00, RidhaH

Which statement correctly identifies the scientific question and describes why the question is scientific? question 1 refers to the supernatural. question 2 reflects a moral or social value. question 3 refers to something that can be measured. question 4 reflects a question that can’t be observed.

Answers: 1

continue

Chemistry, 22.06.2019 12:00, BreBreDoeCCx

Ageochemist examines a piece of metal that he found in the soil. he performs tests to identify the metal from its density, electrical conductivity, and melting point. which statement best describes his investigation? a. he is determining physical properties that are sufficient to identify the metal. b. he is determining chemical properties that are sufficient to identify the metal. c. he is determining physical properties that are insufficient to identify the metal. d. he is determining chemical properties that are insufficient to identify the metal.

Answers: 3

continue

You know the right answer?

how does the concentration of sodium thiosulphate affect the rate of reaction in between hydrochlori...