Balance the equation below and pick the choice with the correct coefficients (1 Point)
K3P04+CaBr2 - >KBr+ Ca3(PO4)2

A 2, 3, 2, 1
B 2, 1, 3, 1
C 2, 3, 6, 1
D 1, 3, 2, 2

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.

answer : one can design an experiment using a liquid and an additive that can be added to the liquid and observe the chemical changes in the reaction species.

one would need a beaker which is filled with a known amount of the liquid in which thermometer is placed to measure the temperature changes; after addition of the additive to the liquid solution one can note down the temperature change and find whether the reaction is endothermic or exothermic in nature. by subtracting the initial temperature value with the final temperature one can find the temperature changes.

various combinations of liquid and additive can be used. liquid in this case can be a known quantity of water and additives can be epsom salt or without epsom salt the experiment can be conducted to notice the changes. water and ice, hydrogen peroxide and dry yeast, vinegar and baking soda,etc.