Formula of a copper (II)sulfate hydrate lab Mass of empty dish: 50.58 g
mass of crystals and dish: 55.63
mass of crystals after first heating: 54.57
mass of crystals after second heating: 53.83
mass of crystals after 3rd heating: 53.74
then it asks for the mass of crystals in the evaporating dish. i said 50.58/55.63x100= 90.94(i’ve yet to round to significant figures) and i’m unsure as to whether or not this is the proper equation?? i get more questions on the crystals for the heating, and then it goes to ask: determine the mass of water evaporated from ye crystals during the heating. If you know what equation to use, please let me know!!

the other questions: using the mass of water evaporated from the crystals after the 3rd heating, determine the percentage by mass of water in the copper (II) sulfate hydrate crystals.

Based on the following formulae fir copper determine the GFM of the hydrate crystals: CuSO4 x 5H2O
then more like that but this ones for the accepted percentage by mass of water in the hydrate crystals: CuSO4x5H2O.

then determine percent error.

Weigh the empty crucible, and then weigh into it between 2 g and 3 g of hydrated copper(II) sulphate. Record all weighings accurate to the nearest 0.01 g.

Support the crucible securely in the pipe-clay triangle on the tripod over the Bunsen burner.

Heat the crucible and contents, gently at first, over a medium Bunsen flame, so that the water of crystallisation is driven off steadily. The blue colour of the hydrated compound should gradually fade to the greyish-white of anhydrous copper(II) sulfate. Avoid over-heating, which may cause further decomposition, and stop heating immediately if the colour starts to blacken. If over-heated, toxic or corrosive fumes may be evolved. A total heating time of about 10 minutes should be enough.

Allow the crucible and contents to cool. The tongs may be used to move the hot crucible from the hot pipe-clay triangle onto the heat resistant mat where it should cool more rapidly.

Re-weigh the crucible and contents once cold.

Calculation:

Calculate the molar masses of H2O and CuSO4 (Relative atomic masses: H=1, O=16, S=32, Cu=64)

Calculate the mass of water driven off, and the mass of anhydrous copper(II) sulfate formed in your experiment

Calculate the number of moles of anhydrous copper(II) sulfate formed

Calculate the number of moles of water driven off

Calculate how many moles of water would have been driven off if 1 mole of anhydrous copper(II) sulfate had been formed

Write down the formula for hydrated copper(II) sulfate.

#*#*SHOW FULLSCREEN*#*#

Explanation:

b. acid is the correct answer @jayxboof all social media

acid : acids are those which accepts an electron-pairs.

base : bases are those which donates ab electron-pairs.

alkali : it is a base that dissolves in water. it is basically a base and the ph greater than 7.

hydroxide ion : it is a poly-atomic ion which is negatively charged.