1. The manufacturer of the vinegar used in the experiment stated that the vinegar contained 5.0% acetic acid. What is the percent error between your result and the manufacturer statement

72.8 % (But verify explanation).

Explanation:

Hello,

In this case, with the following obtained results, the percent error is computed as follows:

Volume of vinegar= 7.0 mL

Volume of NaOH= (7+6.6+6.4)/3= 6.7 mL

Used concentration of NaOH= 1.5M

Concentration of acetic acid= (concentration of NaOH*volume of NaOH)/volume of vinegar= (6.7mL*1.5M)/7.0M= 1.44M

Assuming we have 100 mL (0.100L) of vinegar, moles of acetic acid in vinegar = 1.44M x 0.100 L= 0.144 mol

Mass of acetic acid in 100g of vinegar = 0.144 mol x 60.0g/mol= 8.64 g

% of acetic acid in vinegar=8.64 %

% error in percentage of acetic acid = [(8.64% - 5.0%)/5.0] x 100=72.8 %

Clearly, this result depend on your own measurements, anyway, you can change any value wherever you need it.

Regards.

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.