Chemistry, 30.11.2019 06:31 goat46

How many naturally occuring isotopes may exist for each element

Answers: 1

Show answers

Answers

Answer from: Quest

some sources quote the lethal dose, for an average 170lbs opiate-naive individual is between 75 and 375 mg

Answer from: Quest

Well technically there are two correct answers b and d. but for you its probably b in general.good day sir/ma'am : ) (i know not gender)

Answer from: Quest

Answerthe half-reaction having the greatest tendency to occur at the anode: i₂(aq) + 2e⁻ ⇄ 2i⁻ ; e = +0.53 v====== $\begin{aligned} \text{i}_2\text{\footnotesize (aq)}+2\,\text{e}^{-} & \rightleftharpoons 2\,\text{i}^{-}\text{\footnotesize (aq)}& \text{e} & = +0.53\text{ v} \\ \text{co}^{3+}\text{\footnotesize (aq)} + \text{e}^{-} & \rightleftharpoons \text{co}^{2+}\text{\footnotesize (aq)} & \text{e} & = +1.80\text{ v} \\ \text{o}_2\text{\footnotesize (g)}+4\,\text{h}^{+}\text{\footnotesize (aq)} + 4\,\text{e}^{-} & \rightleftharpoons 2\,\text{h}_2\text{o}\text{\footnotesize(l)}& \text{e} & = +1.23\text{ v} \\ \end{aligned}$ oxidation occurs at the anode. we must therefore find the half-reaction with the greatest tendency to oxidize.the given values of e are reduction potentials (the form of the half-reactions are of reduction).the lower the reduction potential, the higher the potential to oxidize. the half-cell with the lowest reduction potential will have the greatest tendency to oxidize at the anode.the half-reaction having the greatest tendency must be i₂(aq) + 2e⁻ ⇄ 2i⁻ e = +0.53 vbecause its reduction potential is the lowest out of the three.

Answer from: Quest

Note that 2 mol dm⁻³ = 2 mol/(dm³)outline: we're given the concentration of hcl, which is 2 mol dm⁻³ (cubic meters in the denominator can represent volume, so i know this is concentration). we're an amount of calcium carbonate caco₃, which is 5 g. we're presented with a chemical equation which includes caco₃ and hcl. we are told to find the volume of hcl. from what we see so far, this seems to be a stoichiometry problem. we'll have to use the given information about calcium carbonate to find the amount of moles of hcl needed to fully react with calcium carbonate. then we'll have information about the moles of hcl and the concentration of hcl; that will be enough to figure out volume according to the formula concentration = moles / volume.======all the answer choices are not in dm.convert the given concentration so that it uses cm⁻³.we can use conversion factors. we have to cube our conversion factors so that dimensional analysis works.we can convert to meters first, using the fact that 10 dm = 1 m ⇔ 10³ dm³ = 1 m³then we use the fact that 10² cm = 1 m ⇔ (10² cm)³ = (1 m)³ ⇔ 10⁶ cm³ = 1 m³so converting: $\dfrac{\text{2 mol}}{\text{dm}^{3}} \cdot \dfrac{\text{10}^3\text{ dm}^3}{\text{1 m}^3} \cdot \dfrac{\text{1 m}^3}{10^6\text{ cm}^3} \\ \\ = \dfrac{\text{2 mol}}{1} \cdot \dfrac{\text{10}^3}{1} \cdot \dfrac{1}{10^6\text{ cm}^3} \qquad \text{\footnotesize cancelling units} \\ \\ = \dfrac{2\text{ mol}}{10^3 \text{ cm}^3} \\ \\ = 0.002\text{ mol/cm}^3$ now we have to find the moles of hydrochloric acid neededfind the moles of calcium carbonate. we have to find the molar mass of calcium carbonate, caco₃, which can be found by molar mass = (mass ca) + (mass c) + 3(mass o) = 40 + 12 + 3(16) = 100 g/molconvert the given 5 g to moles: mol caco₃ = 5 g caco₃ * 1 mol/(100 g) = 0.05 mol caco₃use stoichiometry (ratios) to figure out the moles of hcl needed. ratio wise, there's 2 hcls for every caco₃, so use dimensional analysis mol hcl = mol caco₃ * (2 mol hcl) / (1 mol caco₃) = 0.05 mol hcl * 2 = 0.1 mol hcl we have 0.1 mol hcl and concentration of hcl (0.002 mol/cm³).we need to find volumesince concentration = moles / volume, rearrange to get volume = moles / concentration volume = 0.1 mol / (0.002 mol/cm³) volume = 50 cm³