Be sure to answer all parts. styrene is produced by catalytic dehydrogenation of ethylbenzene at high temperature in the presence of superheated steam. (a) given these data, find δh o rxn , δg o rxn , and δs o rxn at 298 k: δh o f (kj/mol) δg o f (kj/mol) s o (j/mol·k) ethylbenzene, c6h5−ch2ch3 −12.5 119.7 255 styrene, c6h5−ch=ch2 103.8 202.5 238 δh o rxn δg o rxn δs o rxn kj kj j/k (b) at what temperature is the reaction spontaneous? °c (c) what are δg o rxn and k at 600.°c? δg o rxn k kj/mol × 10 enter your answer in scientific notation.

a) ΔHºrxn = 116.3 kJ, ΔGºrxn = 82.8 kJ,  ΔSºrxn =  0.113 kJ/K

b) At 753.55 ºC or higher

c )ΔG =  1.8 x 10⁴ J

    K = 8.2 x 10⁻²

Explanation:

a)                                 C6H5−CH2CH3  ⇒  C6H5−CH=CH2  + H₂

ΔHf kJ/mol                    -12.5                           103.8                      0

ΔGºf kJ/K                        119.7                         202.5                      0

Sº J/mol                          255                          238                      130.6*

Note: This value was not given in our question, but is necessary and can be found in standard handbooks.

Using Hess law to calculate  ΔHºrxn we have

ΔHºrxn  = ΔHfº C6H5−CH=CH2 +  ΔHfº H₂ - ΔHºfC6H5−CH2CH3

ΔHºrxn =     103.8 kJ + 0 kJ  - (-12.5 kJ)

ΔHºrxn = 116.3 kJ

Similarly,

ΔGrxn = ΔGºf C6H5−CH=CH2 +  ΔGºfH₂ - ΔGºfC6H5CH2CH3

ΔGºrxn=   202.5 kJ + 0 kJ - 119.7 kJ  = 82.8 kJ

ΔSºrxn = 238 J/mol + 130.6 J/mol -255 J/K = 113.6 J/K = 0.113 kJ/K

b) The temperature at which the reaction is spontaneous or feasible occurs when ΔG becomes negative and using

ΔGrxn =  ΔHrxn -TΔS

we see that will happen when the term  TΔS  becomes greater than ΔHrxn since ΔS  is positive  , and so to sollve for T we will make ΔGrxn equal to zero and solve for T. Notice here we will make the assumption that  ΔºHrxn and ΔSºrxn remain constant at the higher temperature  and will equal the values previously calculated for them. Although this assumption is not entirely correct, it can be used.

0 = 116 kJ -T (0.113 kJ/K)

T = 1026.5 K  =  (1026.55 - 273 ) ºC = 753.55 ºC

c) Again we will use

                       ΔGrxn =  ΔHrxn -TΔS

to calculate ΔGrxn   with the assumption that ΔHº and ΔSºremain constant.

ΔG =  116.3 kJ - (600+273 K) x 0.113 kJ/K =  116.3 kJ - 873 K x 0.113 kJ/K

ΔG =  116.3 kJ - 98.6 kJ =  17.65 kJ = 1.8 x 10⁴ J ( Note the kJ are converted to J to necessary for the next part of the problem )

Now for solving for K, the equation to use is

ΔG = -RTlnK and solve for K

- ΔG / RT = lnK  ∴ K = exp (- ΔG / RT)

K = exp ( - 1.8 x 10⁴ J /( 8.314 J/K  x 873 K)) = 8.2 x 10⁻²

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.