subject
Chemistry, 20.09.2019 22:10 hokamidat

Aliquid mixture containing ethanol (55.0 wt%) and the balance water enters a separation process unit at a rate of 90.5 kg/s. a technician draws samples of two product streams leaving the separator and analyzes them with a gas chromatograph, obtaining values of 86.2 wt% ethanol (product stream 1) and 10.9% ethanol (product stream 2). the technician then reads a manometer attached to an orifice meter mounted in the pipe carrying product stream 1, converts the reading to volumetric flow rate using a calibration curve, and converts that result to a mass flow rate using the average density of ethanol and water. the result is 54.0 kg/s. finally, the technician calculates the mass flow rate of the second product stream using a material balance and reports the calculated product stream flow rates and compositions to you. you examine them, do some calculations, and reject them.(a) draw and label a flow chart of the separation process.(b) carry out the calculations that led you to reject the submitted results and explain how you knew the values were wrong.(c) list up to five possible reasons for the incorrect results. for each one, briefly state how you might determine whether it was in fact a cause of error and what you might do to correct it if it was.

ansver
Answers: 3

Other questions on the subject: Chemistry

image
Chemistry, 21.06.2019 23:30, 23gordns
Problem #3 (ch. 1, problem 15)the ideal gas law provides one way to estimate the pressure exerted by a gas on a container. the law isí‘ťí‘ť=푛푛푛푛푛푛푉푉mo re accurate estimates can be made with the van der waals equationí‘ťí‘ť=í‘›í‘›í‘›í‘›í‘›í‘›í‘ ‰í‘‰â’푛푛푟푟â’푞푞푛푛2í‘ ‰í‘‰2where the term nb is a correction for the volume of the molecules and the term an2/v2is a correction for molecular attractions. the values of a and b depend on the type of gas. the gas constant is r, the absolutetemperature is t, the gas volume is v, and the number of moles of gas molecules is indicated by n. if n = 1 mol of an ideal gas were confined to a volume of v = 22.41 l at a temperature of 0â°c (273.2k), it would exert a pressure of 1 atm. in these units, r = 0.0826.for chlorine gas (cl2), a = 6.49 and b = 0.0562. compare the pressure estimates given by the ideal gas law and the van der waals equation for 1 mol of cl2 in 22.41 l at 273.2 k. what is the main cause of the difference in the two pressure estimates, the molecular volume or the molecular attractions?
Answers: 1
image
Chemistry, 22.06.2019 15:30, elizabethprasad2
The reactions of photosynthesis occur in the of plant cell? a. mitochondria. b. lysosomes. c. chloroplasts. d. chlorophyll
Answers: 1
image
Chemistry, 22.06.2019 20:00, bettybales1986
Glucose (c6h12o6) is an important biological molecule. (round the answer to nearest hundredth.) what is the percent by mass of carbon in glucose?
Answers: 2
image
Chemistry, 22.06.2019 21:20, 50057543
Phosgene (carbonyl chloride), cocl2, is an extremely toxic gas that is used in manufacturing certain dyes and plastics. phosgene can be produced by reacting carbon monoxide and chlorine gas at high temperatures: co(g) cl2(g)⇌cocl2(g) carbon monoxide and chlorine gas are allowed to react in a sealed vessel at 477 ∘c . at equilibrium, the concentrations were measured and the following results obtained: gas partial pressure (atm) co 0.830 cl2 1.30 cocl2 0.220 what is the equilibrium constant, kp, of this reaction
Answers: 2
You know the right answer?
Aliquid mixture containing ethanol (55.0 wt%) and the balance water enters a separation process unit...

Questions in other subjects:

Konu
Mathematics, 29.01.2020 01:47
Konu
Mathematics, 29.01.2020 01:47