The intentional, deliberate misstatement, or omission of material facts or accounting data that is misleading and, when considered with all the information made available, that would cause the reader to change or alter his or her judgment or decision is defined by the association of certified fraud examiners as:

Accublade castings inc. casts blades for turbine engines. within the casting department, alloy is first melted in a crucible, then poured into molds to produce the castings. on may 1, there were 230 pounds of alloy in process, which were 60% complete as to conversion. the work in process balance for these 230 pounds was $32,844, determined as follows: exercises during may, the casting department was charged $350,000 for 2,500 pounds of alloy and $19,840 for direct labor. factory overhead is applied to the department at a rate of 150% of direct labor. the department transferred out 2,530 pounds of finished castings to the machining department. the may 31 inventory in process was 44% complete as to conversion. prepare the following may journal entries for the casting department: the materials charged to production the conversion costs charged to production the completed production transferred to the machining department determine the work in process"casting department may 31 balance.

The answer here, x=7, is not in the interval that you selected in the previous part. what is wrong with the work shown above?

1. alwaysrain irrigation, inc. would like to determine capacity requirements for the next four years. currently, two production lines are in place for making bronze and plastic sprinklers. three types of sprinklers are available in both bronze and plastic: 90-degree nozzle sprinklers, 180-degree nozzle sprinklers, and 360-degree nozzle sprinklers. management has forecast demand for the next four years as follows: both production lines can produce all the different types of nozzles. the bronze machines needed for the bronze sprinklers require two operators and can produce up to 12,000 sprinklers. the plastic injection molding machine needed for the plastic sprinklers requires four operators and can produce up to 200,000 sprinklers. three bronze machines and only one injection molding machine are available. what are the capacity requirements for the next four years? (assume that there is no learning.)